DBSTalk Forum banner

Discussions Showcase Albums Media Media Comments Tags

1-5 of 5 Results
  1. Hopper System Support Forum
    The tech could use a tap at the receiver to feed the Joey (currently tv2) and use a splitter from the node for the for the other 2 joeys. (both 211s) He doesn't need to run a new line. Hopefully he understand how the tap works.
  2. Hopper System Support Forum
    The installation can be done because 1 hopper only need two ports out three coming out of 1000.2/1000.4 lnb's. However, dish doesn't allow mixed equipment to be active on the same account.
  3. Hopper System Support Forum
    Not necessarily, the duo node can be install outside and with the use of a tap inside before the splitter you only need one line from the outside. As long as you are installing a maximum of 1 hopper and 3 joeys.
  4. Hopper System Support Forum
    You need to use a dpplus signal... You can use a dpplus lnb (110,119) a 44 switch, a 33 switch 1000.2 western (110,119,129), 1000.2 eastern ( 61.5, 72,77) or the same orbital locations for a 1000.4, but YOU CANNOT USE DPPRO EQUIPMENT, OR LEGACY EQUIPMENT SO YOU CANNOT USE A 34 SWITCH.
  5. Hopper System Support Forum
    The cables you need are two cables from the dish to the node, one cable from the node to the hopper and one cable from the node to each Joey that can be split with the use of splitters. If you have two cables to each location you have more than enough.
1-5 of 5 Results
Top