I learned that I could setup timers using Dish Pass for the 922 if I go to the older Dish Remote Access URL. I then deleted several of my timers, which were set for specific channels, and added Dish Pass timers set to look at "All Channels". Everything seemed to be going great, instead of having 3 separate timers for CSI: NY, Miami and CSI, I had one timer setup for "CSI:". I then went to my DVR to check my timers and in the guide it shows the recordings are not going to record (the little X thru the guide entry). I then tried to add a timer for one of the CSI's using the 922 method set for a specific channel. It also showed the event was not going to record. I deleted all of the timers associated with CSI and again, manually setup the timer using the 922 method. It now shows that it is going to record. Does Dish Pass really work with the 922 when setup using the older version of Dish Remote Access? Should I go back in and delete all of the other timers I just added using Dish Pass and re-add them using the 922?