Another hiccup

Discussion in 'DIRECTV - SWMLine Discussion (private)' started by MIAMI1683, Apr 20, 2008.

  1. MIAMI1683

    MIAMI1683 New Member

    2,570
    0
    Jul 11, 2007
    So I got an R16-300 yesturday. It setup easily at first, but my HR20-700 lost all of the signal it had. When I rebooted it stuck at 0% again at aquiring guide inofrmation for a couple of minutes. So I unplugged the H21 and it began to load. So when it finished all the channel mappings were wrong. I did an RBR and it loaded correctly. I checked it this morning and all is working well. Now the setup is.

    SWMLine > Skywalker 4-way splitter > leg 1 to HR21-700 > leg 2 to R16-300 > leg three to PI > HR20-700 > leg 4 to H21. The H21 hasn't been rebooted yet. By my count thats only 7 tuners on the SWMLine. This should work perfectly,but the HR20 was still down last night. Just a thought but maybe when adding a reciever to this system the PI should be reset. I didn't do that. I will continue to watch it over the next couple of days.
     
  2. RobertE

    RobertE Active Member

    8,024
    0
    Jun 9, 2006
    Your post shows 7 tuners but your sig shows 9. :confused:
     
  3. MIAMI1683

    MIAMI1683 New Member

    2,570
    0
    Jul 11, 2007
    You are right, the HR20-100 is not hooked up to it. It's like a $5 a month spare right now. I also have an Owned H20 sitting in a box. I have no need for it right now, but you never know,
     
  4. MIAMI1683

    MIAMI1683 New Member

    2,570
    0
    Jul 11, 2007
    Its RED

    The H21-100 IS having problems today. I changeD the channel and I gOt the muti-switch problem message. I then get the 771 message for about 5 mins. then the channel comes back. I rbr it and its still having the problem. The hr20-700 also froze and had to rbr it right after the race today any ideas?

    kate-
     

Share This Page

spam firewall