can`t reprogramme hr24 ird to 18 round dish

Discussion in 'DIRECTV General Discussion' started by prop, Dec 7, 2018.

  1. prop

    prop New Member

    30
    0
    May 2, 2006
    i am trying to use a small 18 dish and i`m trying to use a hr 24 that i was using on a slimline 3 lnb.it says cannot detect signal but i have good numbers on the 101 sat.i can get it to go to downloading guide but it stops at 98%.i`m wondering if it has to do with direct tv phasing out sd.any ideas?
     
  2. slice1900

    slice1900 Well-Known Member

    9,517
    1,139
    Feb 14, 2013
    Iowa
    You have good numbers for at least 26 transponders on 101? And you've gone into satellite setup and changed it to the 18" round dish and multiswitch?
     
  3. Claude A Greiner

    Claude A Greiner New Member

    26
    1
    Dec 7, 2018
    It almost seems as if the receiver is still stuck in SWM mode.

    If it was on SWM, it’s a pain sometimes to switch to multi switch.


    Sent from my iPhone using Tapatalk
     
  4. prop

    prop New Member

    30
    0
    May 2, 2006
    i don`t have 26 transponders i think that is part of the problem. the ones i get are all in mid to high 90`s.i went to satellite settings and changed to 18 round and never had it on swm to begin with
     
  5. studechip

    studechip Godfather

    1,689
    109
    Apr 16, 2012
    Sounds like you are pointed at the wrong satellite. Which transponders are you showing with signal?
     

Share This Page