Separate names with a comma.
Discussion in 'ViP612/622/722/722K DVR Support Forum' started by Ron Barry, Jul 20, 2007.
Here's a pic of what I see at the test screen. Tv is a KDS-70Q006, HDMI connection is direct.
Got 409 on my 65" RPTV last week but it uses component input. Have a new Samsung 37" LCD in the bedroom with a 2nd 622 that still hasn't received 409. Since it's connected via HDMI, I'm glad it hasn't. I wonder if E* has stopped sending 409 after all these complaints. Sounds like a serious issue with 409.
VIP662 ---> PT-AX100U
With the switch (2X1 Manual HDMI Switch - Push Button Type) or without the switch flicker is same
HDMI Test shows nothing...
Should I call DishNetwork?
I have a problem occasionaly that was introduced with L 4.05 . I sometimes get a staticky or white snow screen on my dvi input when I turn on the 622 or I reboot it. I am using hdmi to dvi adapter. It is usually easy to fix by turning off the tv and then turning it on again.
Roll back to 405, it's ok now.
My HDMI had physically failed, but I put a rubber band on it last night (pulling it to the center of the unit) and it's working now.
DISH -cutting edge technology - but we don't forget the past. Use a rubber band on your hdmi cable if any problems.:sure:
Unfortunately, it won't last forever. This is the well-known 'broken solder joint' connector failure. Get a replacement, unless you want to use component. On the other hand, chewing gum might well fix it permanently.:lol: