1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Directv Remote Programming

Discussion in 'DIRECTV General Discussion' started by knoxbh, Mar 14, 2018.

  1. knoxbh

    knoxbh Legend

    184
    5
    May 1, 2002
    Have tried to program my Directv remote (Model No. RC66RX) to control my A/V receiver (Denon). I keep getting a message that after holding down the MUTE and SELECT buttons, a light comes up above the MENU button. There is no light above the MENU button. What model remote should I have to a light above the MENU button?

    Thanks for your help.
     
  2. studechip

    studechip Godfather

    1,606
    99
    Apr 16, 2012
    There are lights at the top of the front of the remote just above the slider switch.
     
  3. makaiguy

    makaiguy Icon

    996
    64
    Sep 24, 2007
    Aiken, SC
    ... one light above each of the four slide switch options.
     
  4. Edmund

    Edmund Remote Master

    1,793
    15
    Apr 17, 2003
    Southern Ca
    If you're seeing a message its because you haven't programmed a tv code to tv device, which there HAS to be one. Once there is, do the following:

    1. av1 or av2
    2. press and hold MUTE & SELECT at the same time, wait for two blinks, release
    3. enter 3 1 3 6 0

    To get the volume in one device:

    1. av1 or av2
    2. press and hold MUTE & SELECT at the same time, wait for two blinks, release
    3. enter 9 9 3
    4. press VOL DOWN

    If you want the denon volume in ALL devices do the following instead:

    1. av1 or av2
    2. press and hold MUTE & SELECT at the same time, wait for two blinks, release
    3. enter 9 9 3
    4. press SELECT
     
    jimmie57 likes this.

Share This Page