Do HD & SD output simultaneously?

Discussion in 'ViP211(411)/211K/222 Support Forum' started by srothaus, Feb 5, 2006.

Thread Status:
Not open for further replies.
  1. srothaus

    srothaus New Member

    2
    0
    Feb 5, 2006
    Does the ViP-211 output HD & SD signals at the same time? My old 6000 only outputs one or the other depending on which mode the box is operating in.
     
  2. James Long

    James Long Ready for Uplink! Staff Member Super Moderator

    50,011
    1,966
    Apr 17, 2003
    Michiana
    :welcome_s srothaus

    Both are always active at the same time.

    With the latest software release (L262) you can even control the aspect ratio separately on the two outputs.
     
  3. bluewolverine

    bluewolverine AllStar

    53
    0
    Jan 21, 2006
    Do both of these features (SD and HD always hot; apect ratio on both) apply to the 622?

    Thanks
     
  4. bluewolverine

    bluewolverine AllStar

    53
    0
    Jan 21, 2006
    and one more question I forgot... Does the remote for the 811 work with the 622? When I went from the 6000 to the 811, the old remote would only work in infrared mode with the 811.

    Thanks again
     
  5. James Long

    James Long Ready for Uplink! Staff Member Super Moderator

    50,011
    1,966
    Apr 17, 2003
    Michiana
    This isn't a 622 forum ... but I believe 'always hot' was in the specs for the 622 as well. The 622 is listed as using the 5.3 IR and 6.3 UHF remotes. The 811 remote might work, but I would not guarantee it.
     
  6. srothaus

    srothaus New Member

    2
    0
    Feb 5, 2006
    Thanks very much. I look forward to getting the new equipment.
     
Thread Status:
Not open for further replies.

Share This Page

spam firewall