DBSTalk Forum banner

DSR-922 / Panasat 1000HD serial ports

2K views 4 replies 2 participants last post by  HDorBust 
#1 ·
Is there a link anywhere to what commands the serial port on the DSR-922 accepts? Does it take commands to move to a particular satellite?

Similar question for the Panasat 1000HD, but will it output the satellite you select on the serial port? (you can probably see where I am going with this).

FYI: Just went live with FTA today, 10' dish, 24" actuator. All parts / receivers / dish / LNBs came from SkyVision. Installation done by New England Antenna (they have a spectum analyzer to really nail the sat positioning). The only thing left is to bury the cable (just laying on the ground for now).

Thanks,
-Dave
 
#5 ·
Apparently what I need is a VBOX or GBOX, I ordered the GBOX. That will replace the 922 (which I will keep as a backup).

The serial port on the 922 was apparently used to interface the HDD 200 (which are no longer available - too bad because there is apparently no way to get HD programming if it isn't FTA).
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top