1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Help getting signal 722 to 1000.2 dish

Discussion in 'ViP612/622/722/722K DVR Support Forum' started by fluebar22, Feb 21, 2016.

  1. fluebar22

    fluebar22 New Member

    2
    0
    Feb 21, 2016
    I have a vip722k dvr receiver I'am trying to hook up to a d1000.2 wa dish. The dish is new. The receiver I moved from al to tx. I'am trying to hook it up with one line temporary till I get a signal. Have it hooked to port one on dish and satalite one on reciever. Zip is 77535. Found settings in dish manual for ele 46. Skew 125. Az 216. Getting nothing. Any ideas?
     
  2. fluebar22

    fluebar22 New Member

    2
    0
    Feb 21, 2016
    For 3 months exactly I have been trying to set my dish up. I've had almost 400 peeps look at this post. I can't f-Ing believe out of 400 peeps that 1 person can't answer my f-Ing question. So I've come to the conclusion that this is site is useless as tits on a nun.
     
  3. RBA

    RBA Well-Known Member

    1,218
    97
    Apr 14, 2013
    TEXAS
    Your attitude and the lack of understanding of installation may be the reason you have no answers. In 3 months you should have been able to call DISH and set up a free dish mover.
     
    1 person likes this.
  4. Jim5506

    Jim5506 Hall Of Fame

    3,732
    48
    Jun 7, 2004
    Does the receiver see the 3 lnbs when you run a check switch?

    After it does, then cover the two outer lnbs with foil and find the 119 satellite with the center lnb only.

    Uncover the outer two lnbs and tweak the azimuth and elevation to maximize signal across all three satellites.
     

Share This Page