Separate names with a comma.
Discussion in 'DIRECTV HD DVR/Receiver Discussion' started by Stuart Sweet, Apr 8, 2009.
Received on 2 x HR20-700 at 3:29 MDT this morning in Boise ID
I think it only the downloads that are pushed to your receiver (like a national release) are listed in history. The downloads that are forced (which is the case for CE releases) aren't there.
Interesting. I live in the same city and I didn't get it.
EDIT:I could be wrong. I just noticed that this is for HR20's only and I didn't check my -100.
When reporting an issue try to remember to go into the misc. menu and generate a report, and use the report # in your posts.
I have been very remiss about doing that with this release, it just slipped my mind. Sorry.
I think you are correct, it makes sense.
Still on 0x2ED on my R22 in Middle TN.
Patience, Grasshopper. It started on the west coast yesterday morning, but from todays post it seems to be slowly working its way east.
Both my HR20's received the updates early yesterday morning.
Both units also do not pass system test 100%, but fail the dish alignment test
(as with the CE version) so now that this is a "official" release should I call in
about the error now? I did not during the CE tests, just used the report tool
as I had expected CE testing to have some possible glitches and as expected
for a "CE" tester did not expect a customer service rep to help me.
I got it here.
Yes, call it in.
I received it yesterday morning on both my HR20 and HR21
Got it early yesterday on the HR20 in my home office. Nothing so far on the HR20 in the living room.
Odd...unless I never noticed it before, it says I have the "slimline" dish when I do not.
I don't get what this is. Where did this SW version come from? Was there a CE release/test cycle for this NR software? Are NRs now being rolled out without going through the CE process? What did I miss? I'm so confused.
I believe that all ce's are tests for the next NR. When the ce works the way it should then it becomes the NR.
Got it on two of my four 20-700s last night. Didn't recognize the eSATA on one and had to reboot both the HR and the eSATA. Normal. If this happens to you, pull the plug on both the HR and the eSATA. Plug in the eSATA and then the HR.
Checked some things and see no problems.
How do you run the system test? And the dish alignment test?
I got overnight on my 20-100 but not on my 22-100.
The 20-100 now has a MRV option ????
Just received in Southwest Michigan @ ~9:30. Oh ya, I have a 20-700
I got mine this morning. It started asking me around 3 AM and I finally let it do it around 4 AM.
I got this morning and it asked me "Update now or update later". I chose later so that my kid could watch a recorded show before we left, and not a minute later it went into update mode for 15 minutes. I like the option for later, but I was hoping for 30 minutes or so before the next prompt.