OK this is really bothering me and really need some help I was helping out someone who has a HR24 and AM21 figure out what zip to load to get guide info for their missing channels (as the HR24 loads the database) so I put a bogus zip into my HR34 and got guide info. Now I can't get the "old" (bogus) guide data out of my HR34. -If the "bogus" market and my market match up with RF stations it shows bogus data for those channels only. -So as example I have 4 stations that have no guide data (not in the database) yet they show guide data for the bogus stations -the PSIP numbers dont even match up so on some channels I can't tune to them now. As example 2-1 is RF34 legit but the bogus its 43. If I tune to 2-1 I get an error -Another PSIP error is in my market its on 7-3 but uses RF45. The bogus uses RF45 too but is suppose to be 24-3 yet it maps to 7-3 How can I get this back to just showing my market??? -I have done a reset (of the antenna...the one below the "edit OTA channels") then did initial install. Put in ONLY my legit zip. Same problem. A few channels have wrong guide info -reset via antenna then did a red button reboot. Then did install. Same problem -did reset then under install put as primary and secondary zipcodes in my market...same thing -even tried a different zip that had only 1 station that matches my market...same issue The issue is if both markets use the same RF station (which are 43, 22, 45 and 29) HELP!!