No Reception

Discussion in 'Standard Definition Receiver Support Forum' started by Mutexx, Aug 14, 2009.

Tags:
  1. Mutexx

    Mutexx New Member

    2
    0
    Aug 14, 2009
    Hey Everyone,

    I'm new to the forum. I'm technically savvy, just not with satellite tv :D

    I'm hoping someone can help steer me in the right direction for my problem,
    and I haven't actually tried anything yet (except removing and inserting the
    card several times).

    I have a dish 500 system, with two 3900 receivers. The receiver in the living
    room works fine. The receiver in my office is constantly acquiring satellite
    signal. If I go to setup, to point dish/signal I get a "not locked" for both
    the 110 and 119 satellites.

    Any ideas would be appreciated.

    Rick
     
  2. SayWhat?

    SayWhat? Know Nothing

    6,262
    136
    Jun 6, 2009
    Have you tried physically swapping the receivers? That will help to isolate the problem to either a bad receiver or bad cable to the one room.
     
  3. Mutexx

    Mutexx New Member

    2
    0
    Aug 14, 2009
    I haven't done that yet... It is the easiest thing to try (except for the cord fishing, lol).

    I'll report back after I try. Thanks.
     

Share This Page

spam firewall