1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Reseting Remote to default

Discussion in 'General DISH™ Discussion' started by mkovacs, Jan 28, 2011.

  1. mkovacs

    mkovacs Cool Member

    Nov 26, 2002
    I have set up my 722 remote to control my stereo.
    I set up the aux device to control the power on/off and volume then swapped this setup to the TV device. I did this more then once and it seems that something is setup incorrectly in the remote. When I turn off the stereo power the 722 will come on! Other things also happen.
    Is there a button combination on the remote to reset it to the factory settings so I can start over and get it set up correctly.
    I looked in the SAT rx manual but could not find anything about this.

    I was going to call Dish tech support but thought I would ask here.



Share This Page