1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

SWM 16 in the works...

Discussion in 'DIRECTV Installation/MDU Discussion' started by k2tech, Sep 1, 2009.

  1. P Smith

    P Smith Mr. FixAnything

    22,600
    240
    Jul 25, 2002
    W.Mdtrn Sea
    VOS, now waiting your words :)
     
  2. veryoldschool

    veryoldschool Lifetime Achiever Staff Member Super Moderator DBSTalk Club

    42,684
    349
    Dec 9, 2006
    Interesting, but confusing at the same time.
    These tests look to be done without the 2.3 MHz FSK control signal.

    [table]8 Channel SWM Frequency Assignment
    Channel 1 974MHz Guide DATA
    Channel 2 1076MHz Program Content
    Channel 3 1178MHz Program Content
    Channel 4 1280MHz Program Content
    Channel 5 1382MHz Program Content
    Channel 6 1484MHz Program Content
    Channel 7 1586MHz Program Content
    Channel 8 1688MHz Program Content
    Channel 9 1790MHz Program Content[/table]

    It's hard to correlate these to your measurements.
     
  3. P Smith

    P Smith Mr. FixAnything

    22,600
    240
    Jul 25, 2002
    W.Mdtrn Sea
    Sure, I did provide only DC power to the LNBF.
     
  4. P Smith

    P Smith Mr. FixAnything

    22,600
    240
    Jul 25, 2002
    W.Mdtrn Sea
    Technical question: is there any generic 2 GHz splitter (not a special SWiM type) what would allow me connect HR22 or H23 and spectrum analyzer same time ?
     
  5. veryoldschool

    veryoldschool Lifetime Achiever Staff Member Super Moderator DBSTalk Club

    42,684
    349
    Dec 9, 2006
    I've used even cable [1 GHz] splitters and had some good ones and others that roll off at the higher channels.

    bCapture.PNG
     

Share This Page