1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

System check error message

Discussion in 'DIRECTV Installation/MDU Discussion' started by thebigeazy, Dec 28, 2012.

  1. thebigeazy

    thebigeazy Cool Member

    48
    0
    May 12, 2006
    South Louisiana
    I am getting the error message 43-594, when I run system check.

    All of the satellites register in the 95-100% range except for the following:

    99c 72-83%
    99s 0%

    103s 54-78%
    103ca 23-69%
    103cb 52-83%

    My package is CHOICE EXTRA. Are these sats needed for the package, and if so, what am I missing.

    Where in the ARC are these two satellites (in degrees) located?

    Thanks
     
  2. veryoldschool

    veryoldschool Lifetime Achiever Staff Member Super Moderator DBSTalk Club

    42,684
    349
    Dec 9, 2006
    two degrees on either side of 101, but it looks like the dish hasn't been fine tuned to the Ka signals. Since they're narrower than Ku [101] it looks like the dish is "just close" to being aligned.
     
  3. jimmie57

    jimmie57 Hall Of Fame

    7,409
    425
    Jun 26, 2010
    Texas City, TX
    You have a strong line of thunder storms moving across the state at this time. Most likely that they are affecting your signals.
    Check them again after the front passes you by and report them back here.
     

Share This Page