1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Upgraded to 722 with ota module

Discussion in 'DISH™ OTA Support and Discussion Forum' started by biz, Sep 20, 2009.

  1. biz

    biz AllStar

    93
    0
    Jul 30, 2004
    I had a 622, and had no issues getting my local OTA channels to appear. I split my cable that runs to the OTA antenna into the tv as well as backup and it got the channels.

    Now ti Upgraded to the 722, and I noticed after scanning, that it does not pick up my local CBS station. Now that Dish offers all of our locals in HD, and with the various mapdowns etc, there are plenty of choices to record this.

    I'm curious about not getting it via the new reciever though.

    I double checked and went to the TV and viewed locals directly and it is still there.
     
  2. harsh

    harsh Beware the Attack Basset

    21,192
    183
    Jun 14, 2003
    Salem, OR
    It would appear that you have a ViP722K as opposed to a ViP722.

    Yes, the distinction absolutely important.

    Have you tried running the antenna straight to the DVR?
     
  3. Stewart Vernon

    Stewart Vernon Roving Reporter Staff Member Super Moderator DBSTalk Club

    21,611
    382
    Jan 7, 2005
    Kittrell, NC
    Harsh is correct... The BIG difference in a 722K vs a 722 is the 722K OTA module supports 2 simultaneous OTA channels for recording... which means the 722K internally splits that OTA signal again.

    This makes a huge difference from your previous once-split situation. Entirely possible that this 2nd split is too much for the channel you are losing.
     

Share This Page