Search Results for ‘splitter’

I currently have a HR44 DVR and two C51 Genie clients connected in my house. I’m not using either of the C51’s right now, so I’d like to move them to me garage/office where they could be of more use. My original plan was to run coax from the current SWM splitter at the back of my house to...

I currently have the working setup as shown in this image. The Dish installer used a HFS-2D splitter to put another RF antenna closer to TV2 for the remote control. Now I want to split off another television to be a mirror of TV2. It's not practical to use a three-way splitter (HFS-3D)...

I need to switch the location of the power inserter. It currently runs directly off the 4-way splitter that is connected to the dish. However, I need it moved to an H25 that is currently connected to a second splitter, which comes after the initial 4-way. Is that possible? Or must the power...

I've got a jumble of equipment here and I'm not sure how to make it all work together. It used to work, but it went down, and during troubleshooting, all the connections at the ViP222K were disconnected. I have two flat screen TVs located about 120 feet away from the ViP222K, and in opposite...

Planning for Genie and SWM conversion and would appreciate (more) advice. Dish feeds to basement where PI would be located. Unclear if SWM will be dish mounted or device in basement. Can I have splitter feed one line from basement to HR34 with hardwired Ethernet, and another line to second...

Well I am new & ordered Directv in August. I ordered NBA League pass on Jan 8th..the last day of the free trial ... I went to cancel a week later but directv site said canceling before 30 days will end me up with a $10 fee.. So I waited until this past Monday ( Feb 6th ). I called them & they...

About 2-3 months ago, my 722 developed a new problem... When I attempt to access any of the DoD menus, I get the message "You must have a broadband connection...". So, I go into "Network Setup" (Menu-6-1-9-2) and "Connection Status" briefly displays "Testing...", then "Connected Online". (I...