DBSTalk Forum banner
Status
Not open for further replies.
1 - 4 of 4 Posts

· Banned
Joined
·
1 Posts
Discussion Starter · #1 ·
i'm fairly new to this and am still trying to understand how to properly install my 1000.2. I have a sv360 premier and will be purchasing 2 more in the near future as soon as i can get this one up and running. my questions are:

1) what port do i connect my receiver to in order to aim the dish?

2) for those with the same type of receiver, what configuration settings should i set them to?

3) can anyone please post a diagram of how my system should be set up?

4) I understand that this dish has an internal switch and three receivers can be connected to it without the use of switch. Would i be able to view the same channels on each receiver?

5) do i set the additional receivers to the same configuration settings when i install them?

I'd really appreciate all of the help i can get. Im getting really frustrated :(
 

· Icon
Joined
·
589 Posts
yea um....i dont think its a good idea to be asking questions about illegal activities here

But there is a lot of reading and research that needs to be done before you even attempt something like this. Posting this where you posted it shows you havent even read anything yet.
 

· Super Moderator
Joined
·
10,091 Posts
Please state what your intent is....

We do not allow hack talk on this website.

If your intent is FTA? You'll be disappointed setting all that up for just NASA TV.

This thread has a time limit on it.... if you do not respond in 24 hours I will assume you were asking about illegal activities and the thread will close.


Regards,
Jason
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top