DBSTalk Forum banner
Cancel

622 - UHF remotes for TV1 and TV2

1109 Views 6 Replies 4 Participants Last post by  CABill, 
B
Can both the TV1 and TV2 remotes be UHF control?
I have seen sets of the remotes on ebay (TV1 and TV2) and wonder if it is possible, how do I make a TV1 UHF remote that works well with TV2 also being UHF?


Edit- Sorry, just read the Remote Options thread and it takes care of my question. Funny how I didn't see that thread while looking over the forum earlier..! :blush:
Save
Like
Status
Not open for further replies.
1 - 1 of 7 Posts
C
To change frequency, Push and hold Sat until the other buttons light, pick some address and hit # key. To make the receiver respond to the remote at the new address, push Record button on remote when the receiver is at the Sys Info screen. TV1 or TV2 should display the new address on screen. It might be easiest to get to Sys Info before changing remote address.

EDIT: I was quite wrong on the 1st paragraph - they do have to be different addresses. I've deleted it.
Save
Like
1 - 1 of 7 Posts
Status
Not open for further replies.
DBSTalk Forum
A forum community dedicated to digital bit streaming enthusiasts. Come join the discussion about programming, content, and reception, home theaters, displays, models, styles, satellites, reviews, accessories, classifieds, and more!
Full Forum Listing
Explore Our Forums
DIRECTV General Discussion DIRECTV HD DVR/Receiver Discussion DIRECTV Programming General DISH™ Discussion DIRECTV Installation/MDU Discussion
Top