Last night I lost all my HD stations, Espnhd, and such. This a.m. I check Sat signals and could see all 5 Sats. Last night I could not. I ran setup and everything is OK except 99b, which fails. I can see a signal on the even transponders with the signal meter, but it will fail on setup. Any ideas? I called DTV and they are sending someone out to align dish again.
99b failing on setup
- Status
1 - 4 of 4 Posts
Joined
·
14,539 Posts
99b doesn't carry those HD stations you lost...
http://www.lyngsat.com/packages/directvusa99.html
I think, not sure, that unless you require 99b, then it will appear as failed. Since you're in Tampa, then your local Mpeg4's are on 102.
http://www.lyngsat.com/packages/directvusa103.html
http://www.lyngsat.com/packages/directvusa99.html
I think, not sure, that unless you require 99b, then it will appear as failed. Since you're in Tampa, then your local Mpeg4's are on 102.
http://www.lyngsat.com/packages/directvusa103.html
yes I realize that. I was just curious about why it is failing setup at this point. And how I can pickup the channels I could not last night. We had perfectly clear weahter here. I have another HR20 and an HR10 and they lost the sats too. I am so use to my HR20 failing that I rebooted immediately when I lost my signal. Did not check the other recievers until after it did no come back correctly.
1 - 4 of 4 Posts
- Status
Join the discussion
