[David MacLeod]

on swm-8 setup I can't terminate the PI ird end and just hook the PI to swm2 and the swm1 to the splitter can I? wondering if I can save a 20 foot cable run.

 

[veryoldschool]

on swm-8 setup I can't terminate the PI ird end and just hook the PI to swm2 and the swm1 to the splitter can I? wondering if I can save a 20 foot cable run.

1. Power MUST be connected to SWM #1
2. You can split before the PI if needed

 

[David MacLeod]

so I could come off swm1 to a splitter then run to pi (terminate ird end) and off splitter to the ird's or the sw8 splitter?
that does save a little bit of a coax run, not sure if its enough to justify though.

I'll keep it simple come off swm1 up into house (on slab) to PI, then out of PI and down under again to the splitter.
I do have a conduit coming up through to allow this.

 

[veryoldschool]

so I could come off swm1 to a splitter then run to pi (terminate ird end) and off splitter to the ird's or the sw8 splitter?
that does save a little bit of a coax run, not sure if its enough to justify though.

I'll keep it simple come off swm1 up into house (on slab) to PI, then out of PI and down under again to the splitter.
I do have a conduit coming up through to allow this.

If you need an answer: yes

 

[David MacLeod]

thanks VOS, splitter due in tomorrow so I want to make sure I understand everything before going live.
swm module and PI are mounted now but not hooked up.