DBSTalk Forum banner
1 - 8 of 8 Posts

·
New Member
Joined
·
2 Posts
Discussion Starter · #1 ·
I have no problem getting my Tivo Series 2 to change channels using the IR cable if the H20 is set to respond to the remote on the main DirecTV slider position. However, on my second H20 that is set to respond to AV1, the Tivo doesn't know a code that will work. Can anyone help? I already searched here and didn't find anything that worked. I have tried manually 00001, 00002, 00003.Thanks
 

·
Hall Of Fame
Joined
·
4,792 Posts
BroccoliRob said:
I have no problem getting my Tivo Series 2 to change channels using the IR cable if the H20 is set to respond to the remote on the main DirecTV slider position. However, on my second H20 that is set to respond to AV1, the Tivo doesn't know a code that will work. Can anyone help? I already searched here and didn't find anything that worked. I have tried manually 00001, 00002, 00003.Thanks
Don't know if this will help.

http://www.dbstalk.com/showthread.php?t=134180
 

·
Remote Master
Joined
·
1,820 Posts

·
Hall Of Fame
Joined
·
4,792 Posts
rudeney said:
Maybe I misunderstood, but I though the OP's problem was getting his stand-alone TiVo Series 2 to control the H20 via the TiVo's IR blaster when the H20 is set to use the "secondary" IR codeset.
Well I did say I don't know if this would help.;)

Sorry about that ,next time I'll leave the answers to the questions I don't totally understand to the Remote Master.:eek: :sure:
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top