DBSTalk Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

· New Member
Joined
·
1 Posts
Discussion Starter · #1 ·
Had my installation yesterday and went very smoothly considering all the problems I've been reading about. However, the installer moved the new AT9 dish to the roof since he said it was too heavy to be mounted on the side of the house where the old 3LNB dish was. In any event he made a short cable run from the old dishes coax cable connections to the roof where there is another set of coax cable connections which ties into the new dish. In both cases, the connections are exposed to the elements and will definetely get wet when it rains/snows etc. Is this right or should they somehow be protected from the weather. I checked that all connections are snug and tight. Is there something more I can do to weatherproof them myself or should I call D* and tell them to come out and do it the right way?

I've heard there are some rubber boots which can be used to cover the connections but that won't work since the two cables are not directly connected but rather they are through some sort of mounting plate that is just laying on the roof but tied to the support mast.

Should I be concerned?

p.s. I've seen the pictures of the Zinwell multi switch connector and that is not what is exposed. These are simply the coax cable connections (two sets of them) that are exposed to the rain.
 

· Registered
Joined
·
12,607 Posts
Hopefully the installer used weather-tight coax connectors with internal O-rings to seal the connections. It shouldn't really matter that the exterior part of the connectors are exposed. But if it concerns you can coat them with weatherproofing compound or heatshrink tubing.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top