DBSTalk Forum banner

DirecTV iPad app can't find receivers

4378 Views 5 Replies 2 Participants Last post by  Throckmorton
Hi,

After updating to the recent v1.5.0 version of the DTV iPad app I can no longer see any of my 3 HD-DVRs. When I go to the settings section they are not listed.

All three DVRs are internet connected, pass all tests and can download on-demand content.

My iPad is in my WiFi network and the IP, subnet mask and gateway are all right for my LAN.

What am I missing?

Additional: I have an HTC EVO phone with a DTV app installed and it works fine. It sees all 3 DVRs. Also, another iPad in the house with the same v1.5.0 iPad app works fine too.
Status
Not open for further replies.
1 - 4 of 6 Posts
Stuart Sweet said:
I don't want to presume, but is this device jail broken, or has it been jail broken?
Both the working and nonworking one are jail broken. I'm not getting any errors about that.
Stuart Sweet said:
Again, I'm not speaking out against jailbreaks, but I know that with jail broken tablets you will generally have reduced function or no function at all.
Yes, I understand... If this iPad is queried, it reports that it is _not_ jail broken. And the app launches fine, which is where it would fail if jail break detection was in play.

Both of my iPads are set up the same and it works fine on the other one. It used to work on this one, then quit.
If anyone should happen across this thread in the future, a just-released update to xCon seems to have resolved the problem.

Thanks to all who offered assistance.
1 - 4 of 6 Posts
Status
Not open for further replies.
Top