DBSTalk Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

· New Member
Joined
·
1 Posts
Discussion Starter · #1 ·
I lost the instructions to my new Dish 1000 triple lnb (110, 119, 129)
each of the three lnb's has to post to attach cable. As I recall the outer two lnb jumper cable is to be disconnected and the middle (119) aimed. Then when aimed connect the jumper.
Questions:
which post of the 110 do I connect to and which post of the 129. The best way to answer would be inside post or outside post.

Which post of the inner lnb do I hook up the single cable to my receiver?

Does the Dish 1000 have a built in switch?
thanks.:rolleyes:
 

· Legend
Joined
·
167 Posts
danc64 said:
I lost the instructions to my new Dish 1000 triple lnb (110, 119, 129)
each of the three lnb's has to post to attach cable. As I recall the outer two lnb jumper cable is to be disconnected and the middle (119) aimed. Then when aimed connect the jumper.
Questions:
which post of the 110 do I connect to and which post of the 129. The best way to answer would be inside post or outside post.

Which post of the inner lnb do I hook up the single cable to my receiver?

Does the Dish 1000 have a built in switch?
thanks.:rolleyes:
Here are some wonderful diagrams:

http://www.satelliteone.com/dish/support/support.html

i am thinking that you might be interested in:

DishPro Plus Twin LNBF Installation
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top