DBSTalk Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
New Member
Joined
·
8 Posts
Discussion Starter · #1 ·
I have a 622, and The way it's wired currently, the TV1 signal is going to an HDTV via a component cable, and TV2 signal is set to a coax splitter and then to other SD sets. I would like to split/route the TV1 signal to a couple of other SD sets via coax. Is there a box that will convert one of the TV1 outputs to coax?
 

·
Icon
Joined
·
860 Posts
No need. The coax output can already have both TV1 and TV2 signals on it. You just have to go into the menu and enable it and tell it which channel you want TV1 broadcast on and which channel you want TV2 broadcast on. I use it and it works well.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top