DBSTalk Forum banner
1 - 3 of 3 Posts

· Cool Member
24 Posts
Discussion Starter · #1 ·
I am getting to move my slimline dish from the roof to the a pole mount on the ground because it will be eaier to clear the snow and ice in the winter.

I bought a new slimline dish to mount on the pole and when I look at the receiver and dishponter.com it states the elavation for my zip code(15626) should be 38 degrees.

However, when I climb on the roof to check the original dish, the elevation is set for 22 degrees on a plumb mast. All signals are in the low 90's.

I would understand a few degrees, but why is there such a discrepancy between the two elevations?

Thanks in advance,

1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.