Fine Tuning help

543 Views 4 Replies 3 Participants Last post by flipptyfloppity, Aug 7, 2008

RxMan1

Discussion Starter · Aug 7, 2008

I've been reading a few posts and think I have been doing the fine tuning wrong. Which bolt/bolts do you loosen to fine tune the elevation and which do you loosen for the azimuth?

For elevation, I've been loosening the one right next to the fine tune knob and leaving the other 2 snug. Is this wrong?

THANKS!

1 - 2 of 5 Posts

Mertzen

· #2 · Aug 7, 2008

RxMan1 said:
which do you loosen for the azimuth?

The two on the bottom front.

RxMan1 said:
For elevation, I've been loosening the one right next to the fine tune knob and leaving the other 2 snug. Is this wrong?

Other way around. The one that controls the knob needs to be tight [ but not overly tight] the two on the outside need to be loose.

Mertzen

· #4 · Aug 7, 2008

Oh and don't forget to tighten everything after done.

1 - 2 of 5 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.