DBSTalk Forum banner
Cancel

Fine Tuning help

544 Views 4 Replies 3 Participants Last post by  flipptyfloppity, 
RxMan1
I've been reading a few posts and think I have been doing the fine tuning wrong. Which bolt/bolts do you loosen to fine tune the elevation and which do you loosen for the azimuth?

For elevation, I've been loosening the one right next to the fine tune knob and leaving the other 2 snug. Is this wrong?

THANKS!
Reply
Save
Like
1 - 1 of 5 Posts
flipptyfloppity
And NEVER loosen the one on the elevation fine tune slider (lag bolt) and the two fine tune lockdown bolts at the same time. Your dish can flop right over if you do that.
Reply
Save
Like
1 - 1 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
DBSTalk Forum
A forum community dedicated to digital bit streaming enthusiasts. Come join the discussion about programming, content, and reception, home theaters, displays, models, styles, satellites, reviews, accessories, classifieds, and more!
Full Forum Listing
Explore Our Forums
DIRECTV General Discussion DIRECTV HD DVR/Receiver Discussion DIRECTV Programming General DISH™ Discussion DIRECTV Installation/MDU Discussion
Top