DBSTalk Forum banner
Status
Not open for further replies.
1 - 4 of 4 Posts

· DBSTalk Club Member
Joined
·
75 Posts
Discussion Starter · #1 ·
So, given the issues with the HR20-700 I'd like to bring my HR10-250 back on line. But, to do it I need a multiswitch as I have 2, 2 tuner recievers already hooked up. One in the living room and one in the bedroom. And the HR10 and HR20 would live in the living room.

I see circuit city and bestbuy sell a Terk multiswitch but it says nothing about compatibility with the AT9 Ku/Ka disk I have.

So, is this a good one or no?
 

· Hall Of Fame
Joined
·
3,682 Posts
thread said:
Thanks JD, anything else I need to go along with this like splitters, terminators, etc?
Nope. Just the 4 wires from the Ka/Ku is enough. The flexports are for 95 and 72.5 dishes if you have them. Can't use any kind of terminators.
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top