DBSTalk Forum banner
1 - 8 of 8 Posts

· New Member
Joined
·
32 Posts
Discussion Starter · #1 ·
Hey all. I just added a brand new HR34 to my setup yesterday. I had a HR24 previously which had a bunch of new shows. Now everything seems to be hooked up correctly, and I can see the recorded content from both DVRs. However, the alphabetical sort on the HR24 works correctly, integrating content from both DVRs. However, on the new HR34, it's mostly correct. However, I've noticed a handful of shows aren't sorted at all. They seem to be just adding to the top of the list in the order I record them. There are also a bunch of shows from the old HR24 that don't get sorted. Resorting does not help at all. Any ideas on what might be going on?

Any help would be appreciated.
 

· Broadcast Engineer
Joined
·
4,146 Posts
This won't be all that helpful, but it might help make more sense out why it is doing this.

You probably know that regardless of the sorting mode, current recordings stack up at the top of the list during the record mode. There has to be some signal sent when the program is done recording so that it will then resort properly. Either that is not being sent reliably or not being received reliably.

With any luck, this is where the bug team will start.

Or at least that is my wild guess. :)
 

· AllStar
Joined
·
170 Posts
There was a recent software DL to all HDDVR's and HMC's that updated some play list options hit the yellow button in the play list and change the list order should solve the problem.
*Disclaimer* I am not fully versed in the HMC bugs but the units I have access too, this worked with current software 0x57C
 

· Godfather
Joined
·
419 Posts
otaliema said:
There was a recent software DL to all HDDVR's and HMC's that updated some play list options hit the yellow button in the play list and change the list order should solve the problem.
*Disclaimer* I am not fully versed in the HMC bugs but the units I have access too, this worked with current software 0x57C
To be more specific, unlike the other DVRs, the HR-34 does not display the list from all the networked receivers properly.

It basically lists the shows alphabetically by each receiver as opposed to listing all shows alphabetically regardless of which receiver they are on.

andjuan said:
This actually worked itself out for me. I figured there was a software update that addresses the bug...
Did this get fixed in 0x0582?
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top