DBSTalk Forum banner

HDMI handshake issue?

1076 Views 2 Replies 2 Participants Last post by  hdtvluvr
I have a Yamaha receiver (firmware version was 1.13 when issue started but have now updated to latest - 1.18 hoping it would help) and an HR20-700. Sometime after (perhaps immediately) the latest national release, I have to turn the HR20 off and back on every time I turn the tv on in order to get a picture. I am using a hdfury3. This setup has worked fine for over 2 years.

Is this due to the new HR20 software? Any ideas?
1 - 1 of 3 Posts
1 - 1 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.