DBSTalk Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Godfather
Joined
·
363 Posts
You need to make sure your mast (pipe) is plumb (level both ways) before trying to peak the dish. If it is not plumb, the settings are meaningless, because they assume that it is plumb. Once it's plumb, set the dish as specified, and start aiming from far to the west (right if standing behind the dish) and slowly swing it to the east.

Also, before you start pointing again, unhook the coax from the receiver and run a checkswitch again to clear the incorrect switch matrix you are showing currently.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top