DBSTalk Forum banner
1 - 1 of 1 Posts

·
Mentor
Joined
·
44 Posts
If you are just going to be switching one receiver back and forth between two locations and you will NEVER have a receiver hooked to both locations at the same time, you could take the line that goes to the room the receiver is in now and unhook it outside. Connect it to a high frequency splitter (all ports power passing) http://www.prosatellitesupply.com/hi-freq_digital_signal_splitter.htm and connect the outputs to the two lines where you will have the receiver connected.

This setup will only work if you are moving the receiver back and forth. You can never use this method if you have a receiver connected in both locations.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top