Help with installation

3024 Views 4 Replies 3 Participants Last post by analogqueen, Jun 6, 2013

harryjaswal

Discussion Starter · May 30, 2012

n someone help me with dish installation please and some information as well please about NSS 6 95 E

Save

1 - 5 of 5 Posts

samrs

· #2 · May 30, 2012

Make sure the mast is plumb and securely attached.

Azimuth and Elevation here http://www.dishpointer.com/

Save

harryjaswal

Discussion Starter · #3 · Jun 5, 2012

Hi samrs,
Can you please tell me what is azimuth as in the attached picture and what's skew for LNB and how to set it up please.

See less See more

Save

harryjaswal

Discussion Starter · #4 · Jun 5, 2012

And it's showing a blocking point I guess, so is it means I can't get the signal????????

See less See more

Save

Not necessarily, Harry. Do you have a clear line of sight to the satellite? Where I am it also shows a "block" of a building that is in line with the satellite, but from my elevation and the actual laser sight (if I were to use one that is) I have a direct line TO the satellite I am trying to receive.

You came in just asking "can someone help me with my installation" did you even install the dish to the pole, or anything yet? Have you installed it and made sure the pole was PLUMB, in other words NOT tilted or skewed- used a spirit level to make sure it's exactly level? How far have you gotten with it so far?

Have you installed it in a professional manner and are unable to receive any signal to the receiver? Please be more specific.

Save

1 - 5 of 5 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Help with installation

harryjaswal

samrs

harryjaswal

Attachments

harryjaswal

Attachments

analogqueen

Top Contributors this Month