DBSTalk Forum banner


1056 Views 5 Replies 3 Participants Last post by  Jhon69
Have a HR10-250.Seems to be hanging onto one channel when I change channels.
When I change channels 3 times the info banner shows it's still on the first channel?:confused:
1 - 1 of 6 Posts
Maybe you are switching back and forth between buffers (using the down arrow) and one of the buffers has stayed on the original channel through the entire process.

You do have two cables run to the receiver, correct?
1 - 1 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.