DBSTalk Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Cool Member
Joined
·
13 Posts
Discussion Starter · #1 ·
Hello All, first time poster here, but long time reader. This is the first question I could not find the answer to, hence the post. I have and HR 20 and a D10 receiver installed right next to each other, (2 tvs to watch 2 NFL games at the same time.) Anyway, is it possible to run both with the same remote? Right now when I change the channel, both receivers change obviously. I programmed the AV1 selector using code 00001, thinking that would just control the D10 in the AV1 spot. Not the case, both receiver's change channels when in the AV1 spot also. Is it possible to dedicate the AV1 spot to the D10 and the DTV spot to just the HR20?
Thanks for the help,
Greg
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top