DBSTalk Forum banner
Status
Not open for further replies.
1 - 5 of 5 Posts

·
Icon
Joined
·
650 Posts
Discussion Starter · #1 ·
My HR20 locked up and after I did a reset the reciever stopped responding to the remote although my 2nd hr20 does respond to this remote. I have reset, unplugged, and reset while removing the access card. Any ideas to get it working again?
 

·
Icon
Joined
·
650 Posts
Discussion Starter · #2 ·
mocciat said:
My HR20 locked up and after I did a reset the reciever stopped responding to the remote although my 2nd hr20 does respond to this remote. I have reset, unplugged, and reset while removing the access card. Any ideas to get it working again?
Thanks in advance
 

·
Icon
Joined
·
650 Posts
Discussion Starter · #3 ·
Forget it it was in the dumb rf mode
 

·
Godfather
Joined
·
256 Posts
Jomanscool2 said:
Yeah, that is truely confusing, i've had it hapen a couple tiime myself.

whats worse is when it does work every other minute..
Help me out here guys. I have my remote set to RF. One of my biggest problems is if I'm watching a program on HD NET or one of the HD channels. If I don't touch the remote for about 15 minutes and then I go to use the remote it doesn't work. The audio and video will keep playing but the DVR will accept no commands from the remote. This has also happenned during a playback of and HD program. It's driving me nuts. I have to reset everything once again. Is this considered a lockup or is a possibly and HDMI or Optical cable problem. I'm lost. Thx.
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top