DBSTalk Forum banner
1 - 4 of 4 Posts

· Legend
161 Posts
Discussion Starter · #1 ·
I have an HR21-700 that is normally connected to two of the four outputs from an SL5 LNB (obviously not a SWM setup). I wanted temporarily to operate the HR21-700 on one satellite output from the SL5 for a testing purpose, but the receiver seemed to take forever to boot up, and I gave up on waiting for it. Is there a need to tell the receiver in some way that it is connected to only one satellite output? If so, how do you do that?
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.