I had DirecTV replace my HR24 after that update because the update broke my HD DVR. Wouldn't get satellite signal, cables were fine, as I tested them and setup was fine (cables, LNBs, SWM, Splitter, DECAs, Etc). Anyway, they gave me a new one, and it works."Ronomy" said:Only the HR23 was updated with the new power saver option when this issue popped up. March 6th I was using the system and all was fine. The new firmware installed at 3AM on the 7th. The H23 I think last week updated and HR20 was updated around the 10th of Feb. All was well after those updates.
Last night I reset the ethernet setup on my HR23 and HR20. Rebooted both and both could connect to the internet and I setup MRV DVR sharing on both. Neither one could see the other...until I turned on the H23 and bingo! The guide lit up on the HR20 and HR23 with recordings on both. I could see the local recordings before i turned on the H23. I know the H23 had not been turned on for several days or at least since before the new HR23 firmware was installed. So that's why I think the power saver off mode on the H23 may have blocked all communications between all the receivers. It was instantanious it all worked after I turned on that final receiver.
So yeah I had rebooted everything but the H23. Didn't have to...all I needed was to turn it on.
Ok. I was just pointing my former problem out anyway and how I had to get them to come fix it after the software update."Ronomy" said:Thanks but it was a network address conflict that caused it. My squeezebox when I power up will use the address it used last and my HR23 had already grabbed that address. The HR23 has been working great since I figured that out.
Sorry for the confusion but it is a condition that can happen.
