DBSTalk Forum banner

HR34 - Remote Control "Receiver Mode question

4434 Views 9 Replies 3 Participants Last post by  DaBearsfan
Hi all,

I have searched the forums, the internet, and read the manual but cannot find the answer to this question. D* just came out today and installed my HR34. It replaced an HR20 that was dying a slow death. I have 3 other receivers, another HR20, HR21, and an R22. They are all run off of the same IR system (IR Receivers/repeaters throughout the house) to control them. I use universal remotes to access the DVR I want. So RF will not work in this case (back to mutiple remotes).

My question is the HR34 is replacing an HR20 that was in Receiver Mode 2. I just looked at the menu of the HR34 and it appears that is no longer an option. Is this true? Or is there another way to program the receiver to accept a different remote code?

Thanks in advance for your help.
1 - 1 of 10 Posts
Newer receivers have a choice of two menu schemes, it depends on the remote you use, see this post:

1 - 1 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.