DBSTalk Forum banner
1 - 6 of 6 Posts

·
Legend/Supporter
Joined
·
284 Posts
Discussion Starter · #1 ·
We noticed when we input the channel number on our Genie receiver that the info banner remains for 30 seconds.

Normal changing of channels it only remains for the 4 seconds we have it set for in Settings/Display/Preferences.

Is there anyway to change that setting of 30 seconds?
 

·
Hall Of Fame
Joined
·
10,120 Posts
After you enter the channel number, press the Enter button on the lower right hand side of the remote and see if it changes.
 

·
Legend/Supporter
Joined
·
284 Posts
Discussion Starter · #5 ·
Ehhh... something is amiss. My parents just had their Genie installed and it does not do this. When the number pad is used to change the channel it is no different than using the channel up and down button. The display does not include the additional info section and it goes away within the time limit set in the Settings/Display/Preferences.

Either there is a way to set this... or one or the other receiver is ill.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top