DBSTalk Forum banner

Install/Switch Question

636 Views 4 Replies 3 Participants Last post by  Johnnie5000
I'm new, I seached, can't seem to find my specific case (if there is such a thing)
The thing I'm trying to figure out is, currently we use a terk bms-58 to split the signal (old dish), I know this will not split the signal for the 5LNB AU9 Dish. What I want to figure out is, the 5LNB AU9 dish has 4 outputs. Can I can hook 2 lines from the dish directly into HR22 (I know this will be fine) then use the other two cables from the output, plug them into the terk bms-58 and split the signal for 3 other tv's (non-hd r15 units)
Thanks in advance
1 - 2 of 5 Posts
Thanks for the fast response, in order to save a little cash, I'm thinking of leaving my old dish/switch setup and then install the new dish directly into the hr22, there's 4 outputs on the dish, can I just pick two?
1 - 2 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.