In this setup, the 23 series boxes don't need bbcs, in fact they never do. All others will need one on each tuner since it's a non swm setup. You need to go into the setup and change it to non swm. I don't remember what the exact setting is.
Installation using existing dish and wiring+
I recently moved to a home that already had the dish installed on the roof. From what I understand, it is the 5LNB slimline. The information on the sticker says Andrew DirecTV Multi-Satellite Ka/Ku LNB 99/101/103/110/119 reception. Built-in multi-switch with 4 outputs compatible with all slimline dish antennas.... Lot No. 07-06-06 CCS6610. The dish has four wires coming down and then connected to wiring in the home using barrels. When I connect my receiver, it doesn't connect, so I attempt to change the dish type to Slimline-5 and the switch type to multiswitch. At my previous residences I have hooked everything up on my own, and it seemed to have worked, but these all used the SWM system. I originally tried using the SWM here, but from what I understand, I don't need it, so essentially the cable comes from the dish, to a barrel, and then to the receiver. I am currently trying to connect the H23-600, but will eventually be also connecting the HR24-100. Am I doing something wrong?
1 - 1 of 6 Posts
1 - 1 of 6 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
DBSTalk Forum
A forum community dedicated to digital bit streaming enthusiasts. Come join the discussion about programming, content, and reception, home theaters, displays, models, styles, satellites, reviews, accessories, classifieds, and more!
Full Forum Listing
Recommended Communities
