DBSTalk Forum banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Legend
Joined
·
202 Posts
Discussion Starter · #1 ·
Just trying out the shared view mode first and I get nothing. Tired various channels on the second TV (channel 60 and channel 40) after setting the modulator to each channel. I get nothing. RG6 is connected out of the back of the 622 to a wall mount to the other room which has the second TV. Shared View mode is set to enabled.

I got the UHF remote setup too and it's operating TV1.

Any quick ideas?
 

·
Legend
Joined
·
202 Posts
Discussion Starter · #2 ·
Nevermind. Hooked up another TV locally and it worked fine but only on cable channels which was strange (channel 110). Will keep messing with it.
 

·
Godfather
Joined
·
260 Posts
See if your TV is set to "cable" tuning instead of "antenna". if so, You can either change the TV setting to antenna, or change the 622 setting to cable. Doing the latter will change the channel number you will need to view it on the TV.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top