DBSTalk Forum banner
Status
Not open for further replies.
1 - 4 of 4 Posts

·
Cool Member
Joined
·
17 Posts
Discussion Starter · #1 ·
Anyone else have this problem? When I set the audio to dolby digital - yes, I lose sound on all dolbyized programs. However, if I cycle my receiver (B&K AVR 307) through its sound modes and come back to dolby digital, I get sound. But, when I change channels, the sound goes off again. Any idea why this is happening?

David
 

·
Lifetime Achiever
Joined
·
30,092 Posts
What software version? Did this continue to occur AFTER the 0x10b update from last night.
 

·
The Shadow Knows!
Joined
·
37,060 Posts
Try pushing "Yellow". This will cycle between the audio feeds. Often times the DD2 feed has no sound.

By the way, welcome, greenflag. Seen a lot of new faces around here last couple of weeks... it's good to see you all.
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top