Losing Two Signals

2446 Views 13 Replies 4 Participants Last post by garys, Aug 11, 2012

phaeton16

Discussion Starter · Jun 9, 2012

Here is my problem I'm in my Rv I set up my 100.2 dish on tripod everything is set. 110 @ 69 sig strength 119 @ 63 signal 129 @ 45 signal Around 5 pm to 6 pm what ever sat that I'm watching that's all I can receive til next morning. I have done the tin foil trick to make sure I'm getting the correct reception on the correct transponder and that's ok, Any ideas what is wrong. When I do a check switch in AM all three light up when I do the Evening only one will light up which ever my station was on. Very Frustrating. I do a system update at 3 am.
Any help would be great...... Steve

Save

Status: Not open for further replies.

1 - 1 of 14 Posts

Ray [email protected] Network

· #2 · Jun 9, 2012

Your coax to the receiver comes directly from the dish or do you have a switch (won't need if only 1 receiver)? Have you checked your splitter on the back of the receiver (Sat IN 1 and 2)? I'm assuming you only have 1 TV? Could be the LNB, too. What's the order of the satellites in the Installation Summary screen? Thanks.

phaeton16 said:
Here is my problem I'm in my Rv I set up my 100.2 dish on tripod everything is set. 110 @ 69 sig strength 119 @ 63 signal 129 @ 45 signal Around 5 pm to 6 pm what ever sat that I'm watching that's all I can receive til next morning. I have done the tin foil trick to make sure I'm getting the correct reception on the correct transponder and that's ok, Any ideas what is wrong. When I do a check switch in AM all three light up when I do the Evening only one will light up which ever my station was on. Very Frustrating. I do a system update at 3 am.
Any help would be great...... Steve

Save

1 - 1 of 14 Posts

Status: Not open for further replies.

Top Contributors this Month