Movers Connection question

738 Views 4 Replies 4 Participants Last post by Kapeman, Jan 24, 2012

Kapeman

Discussion Starter · Jan 24, 2012

I currently have an MRV/SWM setup and may be moving.

I assume if I use the Movers Connection program they will setup the same in the new house with no charges for the SWM gear. Is that correct?

I know that I could be charged for any extra wire pulls, etc.

How much does that typically run?

The new house is wired with COAX and I assume DTV can just use the existing wiring (I hope).

I also plan on using cable for Internet access and need to be able to split out that one cable from the DTV install.

Am I missing anything?

Thanks!

I am a long-time/good standing customer if that comes into play.

Save

1 - 2 of 5 Posts

Kapeman

Discussion Starter · #5 · Jan 24, 2012

upmichigan said:
I paid $90.00 for a wall fish and pole mount to boot...I think I got a deal. Mastec did the work.

I don't think (hope) that I will need a pole mount. I should have a pretty good S-SW exposure. The only issue could be the dish placement with respect to where the cable comes into the house.

The Merg said:
As long as the cable runs in the new house are homeruns, you shouldn't have an issue. With regard to Cable Internet, you just need to make sure that one coax is not used by the DirecTV installer. If you currently have SWM/MRV, you will get that at the new house for no cost with Mover's Connection.

As mentioned though, if you have any wall-fishing done, there will be a charge.

- Merg

Thanks for the responses.

Save

1 - 2 of 5 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month