DBSTalk Forum banner

MPEG 4 question

457 Views 1 Reply 2 Participants Last post by  bonscott87
If I was getting signals in the 90's on all my sats, but the new sats are only getting 30's/40's, and the installers say it's a tree that's causing it, could that be true? Would a tree affect only certain signals?
1 - 2 of 2 Posts
If you have 90s on 101 and you're getting those 40s on 99 and 103 I highly doubt that it's a tree since obviously 99 and 103 are right next to 101. So unless you're pointing at a hole in the trees and it's a small hole you aren't going to have tree problems.

Dish simply just needs to be properly aligned for the new sats.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top