DBSTalk Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
AllStar
Joined
·
82 Posts
Discussion Starter · #1 ·
hooked up my HR20 & new 62 inch DLP toshiba today. noticed a big delay when changing channels with native on (and off) - is this normal ? how long should the delay when changing channels be ? :confused:
 

·
AllStar
Joined
·
82 Posts
Discussion Starter · #3 ·
RAD said:
You're noticing the delay when changing channels between different resolutions (such as 71/Showtime which is 1080i and 72/ESPN2 which is 720p) or all channels? If it's when changing between channels of different resolutions it's probably your set needing to sync up with the new resolution, all three if my sets do the same thing. If you don't use native then all the channels are leaving the HR20 at the same resolution so TV doesn't need to re-sync.
its on all channels & when i took the native off the HR20, there is still a delay of a few seconds....any advice ? :confused:
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top